::Pool Supplies:
Liner Accessories:
Gladon Peel & Place Pool Cove
 | |
Gladon Peel N' Place cove is easy to install in any pool. Just peel off the release paper and place into position on a clean, dry pool wall. The super tacky adhesive backing will hold the lightweight, flexible cove sections in place until the liner is filled with water. The Gladon Peel N' Place design is not a new concept. This feature was included as part of Gladon's original patent. How is Gladon Peel N' Place cove different from the Original Cove™??? The unique plastic backing strip found on Original Cove is replaced with a super tacky adhesive backing. The adhesive backing attaches the cove to the pool wall whereas, the backing strip locks each section of cove into the bottom rail. Peel N' Place cove must be installed on a clean, dry pool wall and the Original Cove™ can be installed no matter what the conditions of the pool wall. These conditions may be difficult to achieve depending on the weather and how much dust is being created when smoothing out the ground inside the pool. Peel N' Place cove is now made with the same high quality foam material as the Original Cove. |
- Super Tacky Adhesive Backing
- Eliminates Tons Of Dirt
- Flexible
- Lightweight
- Adheres To Pool Wall
- Extends Pool Life
- Installs In Minutes
- Can Not Wash Out
- Helps Prevent Corrosion
- Over 20 Years Of Proven Performance
- Saves Hours Of Installation Time
- Easy To Handle 4 Foot Sections
- Eliminates Liner Failures Due To Cove Washout
|
|
