The Grit-Gitter comes with two nozzles - a smaller nozzle for
tight places like hot tub corners, filter compartments, and
fountains - and a wider nozzle for larger spaces like swimming
pool steps and kiddie pools
So easy to use.
Just 3 simple steps.
1.
FILL THE BULB WITH WATER
by submerging the Grit-Gitter with the bulb end down. Squeeze
the bulb one or two times to help remove the air.
2.
AIM & SQUEEZE
in one smooth easy motion, squeeze the bulb, and releasing the
bulb quickly, move the GRIT-GITTER forward (3 to 6 inches)
over the grit. A momentary delay before squeezing again works
best.
3.
CLEAN!
Not only does the GRIT-GITTER make cleaning easy, it cleans
easily too. Just empty the contents outside your tub and rinse the
screen. Clean frequently, or whenever squeezing the bulb squirts
grit and water out of the nozzle.
To empty the debris, rotate the bulb counter-clockwise 15° and
pull the bulb/ring straight away from the body. Dump the
contents outside the tub. Fill the bulb with water and pour over
the screen to rinse all the debris off the screen. Be sure no
debris remains in the connection area so that there is no
interference when you reassemble the bulb to the body. To
reassemble, line up the red mark on the body and the red dot on
the ring. Push the bulb into the body and rotate the bulb
clockwise 15° until the ring locks in place.
NOTE: Anything larger than 3/8" in diameter could dislodge
the GRIT-GITTER's inflow check valve. If this should happen,
empty the debris and reattach the check valve by hooking the
posts into the appropriate slots.
The GRIT-GITTER is designed to come apart under stress to
prevent parts from breaking. If your GRIT-GITTER should
come apart, simply reassemble it as you would after cleaning.
|
